Each digital camera user has discovers after some time at the spot of their pictures, which should not be on them. How often turns out, the cause of contamination of photographs is a dirty sensor camera. Therefore, sooner or later it will be necessary to purge the matrix, which in many cases, you can perform yourself.

Contrary to widespread opinion, cleaning the sensor is not a task too complicated, so there is no reason to fear it, but surely you must be careful. If only we have access to the inside of the camera, this operation is relatively simple. Therefore, the owners of SLR cameras are in a better situation, because, have direct access to the matrix - only enough to remove the lens and activate the desired function. So they can without any impediment to clear it yourself - for this service on the site have to pay. In a worse situation, unfortunately, there are compact users who have to do this the camera would have broken into pieces. Therefore, amateurs using digital cameras with optical advise against self-matrix of dust, because it threatens the loss and damage warranty compact. The following method is addressed solely to the owners of digital SLR cameras.

There are two methods of cleaning the image sensor: dry and wet. With the first removed from the sensor all the volatile particles (pollen, dust, sand, etc.), and the second is used for disposal of oily stains. Apart from that, however, remove the dirt, it first must be collected (dry) from the surface of the matrix small pieces of dust with a vacuum cleaner, pears or electrostatic pędzelka to severe grain, such as sand, we do not scrath the sensor. The entire operation performed by holding the camera down the lens mounting and note that the vacuum inside of the body of the wall - otherwise, which is on the dust in a short time again dirts the matrix.
 
If you have fat on sensor spots in the next step we will have to wash your so-called wet method by means of special liquid. Before washing, always performs a dry-cleaning! Using the first time with a good liquid test it before use (check that does not leave behind a smug white) using the sample surface such as washing mirrors. Only after this test, we can proceed to remove the spots from the matrix. Just remember that the liquid on spatula (not directly on the sensor!), Which is a very delicate area of mash filter. After the cleaning, turn off the camera, wind-lens i. .. Done. Now we can take a picture again and see if we removed all the dirt.
 
In conclusion, the cleaning of the matrix is not a complicated task, but it requires special precautions. It is therefore not allowed to ignore this step - can cause scratching antyaliasing filter, which cost substantial money. But to work with sensitivity and attention to safely vacuum sensor, and enjoy the "clean" images. The best way to clean the matrix, however, is its avoidance of ... dirt. It is obvious - even the seemingly trivial - the statement is, however, the best prescription to avoid problems posed by pollution sensor. Therefore, our fight against dust and stains on a matrix of fat you may start with a permanent camera in the maintenance and cleanliness of care when changing lenses - it is mostly through a lens mounting dirt enters the interior of the body.